Many hot air generators and dryers still run on manual settings: an operator watches a gauge and adjusts fuel or dampers by experience. That works until the feed rate, moisture or fuel quality changes, and then the unit runs too hot or too cold. Basic automation keeps it on target.
What a good control panel does
- Measures temperature where it matters: HAG outlet, dryer inlet and dryer outlet
- Adjusts fuel feed or burner firing to hold the set temperature
- Controls fan and drive speeds through VFDs
- Gives alarms and safety interlocks for high temperature and flame failure
- Logs data so you can see trends and fuel use
Where the savings come from
Overheating wastes fuel and can damage both the product and the lining. Underheating leaves the product wet and forces re-drying. Holding the temperature steady, and cutting fuel automatically when the feed drops, avoids both. VFDs on fans and drives also save power compared with running at full speed against a closed damper.
Upgrading an existing plant
Controls can often be added to an existing HAG, furnace or dryer without replacing the equipment. Start with reliable temperature measurement, then add fuel or burner control, then VFDs and data logging.
Data we need
- Equipment type and size
- Fuel and firing system
- Present instruments and controls
- Target temperatures, and how much they vary today
JISPL supplies control panels with temperature and burner controls, and VFD panels, for the equipment we build and as upgrades for existing plants.
Send us the details and get a quick quotation or a site visit.