ISO 9001:2015 certified. Manufacturer, supplier and lining contractor. +91 70140 37172jmd@jispl.net@jmd.jispl

Home / Blog / Equipment

Equipment

Rotary dryer buying guide: the data that decides size, fuel use and price

JISPL teamOctober 20267 min read

A rotary dryer looks simple: a turning drum, hot air and wet material. Whether it reaches its output at a sensible fuel cost depends on a handful of figures that should be fixed before anyone quotes a price.

The figures a supplier needs

  • Material and how it behaves: free flowing, sticky, dusty, abrasive or heat sensitive
  • Capacity in tonnes per hour of dry product, not wet feed
  • Moisture at the inlet, and the moisture you need at the outlet
  • Bulk density and particle size range
  • The highest temperature the material can take
  • Fuel available for the hot air generator: coal, briquette, biomass, oil or gas
  • Space available, where the feed comes from and where the product goes

Why moisture matters most

The heat a dryer needs is driven mainly by the water it has to evaporate. Taking a material from 12% down to 1% moisture means removing more than twice as much water as taking it from 6% to 1% at the same output. That evaporation load sets the size of the hot air generator, the drum and the fans, which is why a quote based on a rough moisture figure is rarely accurate.

Co-current or counter-current

In a co-current dryer, hot air and material travel the same way, so the hottest air meets the wettest material. This suits heat-sensitive materials. In a counter-current dryer they move in opposite directions, which uses heat more efficiently and can reach a lower final moisture, but the dry product meets the hottest air. The material decides which one fits.

Drum, flights and drive

Lifting flights inside the drum shower the material through the hot air, and their shape and number decide how well the heat is used. Drum diameter, length, slope and speed set how long the material stays inside. Riding rings, support rollers and the drive must be sized for the loaded weight and aligned correctly, or wear and breakdowns follow.

The hot air generator and controls

The HAG has to supply the required heat at the right inlet temperature, steadily. Temperature control at the dryer inlet and outlet, and firing control that responds to load, keep the product consistent and stop fuel being wasted when the feed rate drops.

Lining and insulation

The HAG, its ducting and the hot end of the dryer need refractory and insulation that suit the temperature. A well-insulated duct delivers more of the heat to the drum, and a sound lining keeps the shell and supports from overheating.

JISPL builds rotary dryers at our associated workshops with a matching HAG, ducting, refractory lining and control panel, and our own team erects and commissions the line. Share your figures and we will come back with a sizing and quotation.

Need help with this on your plant?

Send us the details and get a quick quotation or a site visit.

Talk to us

Need material, equipment or a lining job?

Send the grade and quantity for rates, or a drawing, BOQ or photo for a job or equipment quotation. We reply with a quick quotation.

Quick quote

Tell us what you need

Enter your name.
Enter a valid phone number.

We reply quickly. Your details are used only to answer your enquiry.

WhatsApp