From the outside, a rotary kiln and a rotary dryer look much the same: a long inclined drum turning slowly on riding rings. Inside, they do different jobs and are built differently.
What each one does
A rotary dryer removes moisture. The material is heated only as far as needed for the water to evaporate, so temperatures stay relatively low. A rotary kiln changes the material itself by calcining, roasting, reducing or sintering it, which needs much higher temperatures, often well above a thousand degrees inside the kiln.
How they are built
- Kiln: a full refractory lining, usually hot face bricks or castables with an insulating back-up
- Dryer: often an unlined steel drum with lifting flights, with refractory only at the hot inlet end where needed
- Kiln: in most designs a burner at the discharge end, with material and gas moving in opposite directions
- Dryer: hot air from a HAG or burner, in co-current or counter-current flow
- Kiln: end seals and a heavier shell and drive to carry the lining
Which one do you need?
If the goal is only to bring moisture down, a dryer is enough and costs less to build and run. If the material must react, change phase or reach a set temperature for a chemical change, it needs a kiln. Some processes use both, a dryer first and then a kiln.
The questions we ask
- What has to happen to the material: drying, calcining, roasting or something else
- The temperature it must reach, and for how long
- Capacity, feed size and moisture
- The fuel available
- Any gases or dust that need handling
JISPL builds rotary kilns and rotary dryers at our associated workshops, lines them with refractory from our own units and commissions them with our own team. Relining and repairs of existing kilns are part of our core work.
Send us the details and get a quick quotation or a site visit.